Park/Neutral Position Switch

2004 Toyota Matrix XR, FWD, StandardSECTION Park/Neutral Position Switch
WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota RAV4, and 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Park/Neutral Position switch may also be referred to as PNP switch.
  1. Check if engine can be started with gearshift lever only in "N" or "P" positions. If adjustment is needed, loosen PNP switch retaining bolt(s). Position gearshift in Neutral. Align neutral line on PNP switch with groove on shaft. See Fig 1 or Fig 2 .
  2. Hold PNP switch in this position and tighten retaining bolt to specification. See TORQUE SPECIFICATIONSΒ . Ensure vehicle only starts with gearshift lever in "P" or "N" position.
Fig 1: Adjusting Park/Neutral Position Switch (Except Avalon)
G00015977Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.