Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 728 (ABS W/ EBD - DIAGNOSIS)DIAGNOSTIC TROUBLE CODE CHART
2004 Toyota Matrix XR, FWD, Standard
Diagnostic Trouble Code Chart
2004 Toyota Matrix XR, FWD, StandardSECTION Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- Using SST 09843-18040, connect the terminals Tc and CG of the DLC3.
- If any abnormalities are not found when inspecting the parts, inspect the ECU and wire harness.
- If a malfunction code is displayed during the DTC check, check the circuit listed in the code. For details of each code, refer to
under the respective "DTC No." in the following DTC chart.
HINT:
There is a case that hand-held tester cannot be used when the ABS warning light is always ON.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.