Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 726 (ENGINE CONTROL SYSTEM - DIAGNOSIS)ACIS CONTROL CIRCUITINSPECTION PROCEDUREOBD II SCAN TOOL (EXCLUDING HAND-HELD TESTER)
2004 Toyota Matrix XR, FWD, Standard
OBD II scan tool (excluding hand-held tester)
2004 Toyota Matrix XR, FWD, StandardSECTION OBD II scan tool (excluding hand-held tester)
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT VSV FOR ACIS (OPRATION)
- Disconnect the VSV for ACIS connector.
- Check operation of the VSV for ACIS when positive battery voltage is applied to the terminals of the VSV for ACIS connector.
Standard:
Positive battery voltage is not applied:
Air from port E flows out through the air filter.
Positive battery voltage is applied:
Air from port E flows out through port F.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.