SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 723 (ENGINE IGNITION SYSTEM (3MZ-FE))INSPECTION
2004 Toyota Matrix XR, FWD, Standard

Section 723 (Engine Ignition System (3MZ-FE)): Inspection

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the following section, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10°C (14°F) to 50°C (122°F). "Hot" means approximately 50°C (122°F) to 100°C(212°F).
  1. INSPECT SPARK PLUG 
    NOTE:
    • Do not use a wire brush for cleaning.
    • Do not attempt to adjust the electrode gap of a used spark plug.
    1. Check the electrode.
      1. Using an mega ohmmeter, measure the insulation resistance.

        Correct insulation resistance:  10 MΩ or more

      If the resistance is less than the specified value, proceed to step  d.

      HINT:

      If the mega ohmmeter is not available, do the following simple inspection instead.

      Fig 1: Measuring Insulation Resistance
      G02853941Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Alternative inspection method:
      1. Quickly accelerate the engine to 4,000 rpm 5 times.
      2. Remove the spark plug.
      3. Visually check the spark plug.
      4. If the electrode is dry, the spark plug is functioning. Proceed to step  2.
      5. If the electrode is damp, proceed to step  c,  d and  e.
      6. Install the spark plug.
    3. Check the spark plug for any damage on its thread and insulator.

      If there is any damage, replace the spark plug.

      Fig 2: Checking Spark Plug
      G02853942Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      RECOMMENDED SPARK PLUG

      DENSO made SK20R11
      NGK made IFR6A11
    4. Check the spark plug electrode gap.

      Maximum electrode gap for used spark plug:  1.3 mm (0.051 in.)

      If the gap is greater than the maximum, replace the spark plug.

      Correct electrode gap for new spark plug:  1.0 to 1.1 mm (0.039 to 0.043 in.)

      NOTE: If adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip. Never attempt to adjust the gap on a used plug.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.