Section 708 (Knock Sensor (3MZ-FE)): Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCHARGE FUEL SYSTEM PRESSURE (See  PRECAUTION  ) 
  2. DRAIN ENGINE COOLANT (See  REPLACEMENT  ) 
  3. REMOVE V-BANK COVER SUB-ASSY (See  REPLACEMENT  ) 
  4. REMOVE AIR CLEANER CAP SUB-ASSY (See  REPLACEMENT  ) 
  5. REMOVE EMISSION CONTROL VALVE SET (See  REPLACEMENT  ) 
  6. REMOVE INTAKE AIR SURGE TANK (See  REPLACEMENT  ) 
  7. REMOVE INTAKE MANIFOLD 
    1. Disconnect the fuel pipe No. 1.
      1. Remove the fuel pipe clamp.
      2. Pinch the tube connector and then pull out the fuel pipe No. 1.
      Fig 1: Pinching Tube Connector & Pulling Out Fuel Pipe No. 1
      G02852859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.