SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 697 (POWER WINDOW CONTROL SYSTEM (COUPE) - DIAGNOSTICS)HOW TO PROCEED WITH TROUBLESHOOTING
2004 Toyota Matrix XR, FWD, Standard

How To Proceed With Troubleshooting

2004 Toyota Matrix XR, FWD, StandardSECTION How To Proceed With Troubleshooting
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use these procedures to troubleshoot the power window control system (coupe).

  1. VEHICLE BROUGHT TO WORKSHOP 
    1. Go To Next Step. 
  2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
    1. Go To Next Step. 
  3. PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE  ) 
    1. If the fault is not listed on the problem symptoms table, proceed to A.
    2. If the fault is listed on the problem symptoms table, proceed to B.
    1. B: Go to step   5 
    2. A: Go to Next Step. 
  4. OVERALL ANALYSIS AND TROUBLESHOOTING 
    1. Terminals of ECU (see TERMINALS OF ECU )
    2. On-vehicle Inspection (see ON-VEHICLE INSPECTION )
    3. Inspection (see INSPECTION )
    1. Go To Next Step. 
  5. ADJUST, REPAIR OR REPLACE 
    1. Go To Next Step. 
  6. RESET POWER WINDOW REGULATOR MOTOR 
    1. If the AUTO switch (driver side switch) lamp of the power window regulator master switch is blinking after the repair, reset the power window motor (see INITIALIZATION ).
    1. Go To Next Step. 
  7. CONFIRMATION TEST 
    1. END 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.