Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE)Β 
    1. Check if the manual UP/DOWN function operates normally.

    OK: Manual UP/DOWN function operates normally.Β 

    1. NG: OTHER PROBLEM (See Β PROBLEM SYMPTOMS TABLEΒ Β )Β 
    2. OK: Go to Next Step.Β 
  2. CHECK LAMP OF POWER WINDOW MASTER SWITCH (DRIVER SIDE SWITCH)Β 
    1. Turn the ignition switch ON.
    2. Operate the master switch driver side switch.
    3. Check the blinking pattern of the AUTO lamp as shown in Fig 2 .
    Fig 1: Identifying AUTO Lamp
    G03049780Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.