Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. RESET POWER WINDOW REGULATOR MOTOR 
    1. Reset the power window regulator motor (see INITIALIZATION ).
    2. Check if the power window AUTO UP/DOWN function operates normally.

      OK: AUTO UP/DOWN function operates normally. 

    1. NG: Go to step   2 
    2. OK: END 
  2. CHECK FRONT DOOR WINDOW REGULATOR ASSY LH 
    1. Remove the door glass (see OVERHAUL ).
    2. Operate the front door window regulator using the switch.
    3. Check if the power window regulator assembly operates smoothly.

      OK: Power window regulator assembly operates smoothly. 

    1. NG: REPLACE FRONT DOOR WINDOW REGULATOR ASSY LH 
    2. OK: REPLACE DOOR GLASS RUN 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.