Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 695 (NAVIGATION SYSTEM - DIAGNOSTICS)MAP DISC CANNOT BE EJECTEDINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard
Inspection Procedure
2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK RADIO AND NAVIGATION ASSY
- Turn the ignition switch to the ACC position.
- Keep pressing the "MAP" eject switch for 5 seconds and check if the disc is ejected by forced ejection.
OK: The disc is ejected.
- NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (SEE PROBLEM SYMPTOMS TABLE )
- OK: Go to Next Step.
- CHECK MAP DISC
- Check that the map disc is not deformed or cracked.
OK: No deformations or cracks appear on the map disc.
- NG: REPLACE MAP DISC
- OK: NORMAL OPERATION
- Check that the map disc is not deformed or cracked.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.