SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 695 (NAVIGATION SYSTEM - DIAGNOSTICS)ILLUMINATION FOR PANEL SWITCH DOES NOT COME ON WITH TAIL SWITCH ONINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard

Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISPLAY CHECK MODE (VEHICLE SIGNAL CHECK MODE) 
    1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (see DISPLAY CHECK MODE (VEHICLE SIGNAL CHECK) ).
    2. Turn the light control switch to the TAIL, HEAD or OFF position.

      Standard: 

      LIGHT CONTROL SWITCH SPECIFICATION

      Light Control Switch Display
      TAIL or HEAD ON
      OFF OFF

    HINT:

    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.

    1. OK: REPLACE RADIO AND NAVIGATION ASSY (SEE  REPLACEMENT  ) 
    2. NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE  ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.