SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 694 (AUDIO SYSTEM - DIAGNOSTICS)DTC CHECK/CLEAR
2004 Toyota Matrix XR, FWD, Standard

DTC Check/Clear

2004 Toyota Matrix XR, FWD, StandardSECTION DTC Check/Clear
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. DIAGNOSTIC CHECK 
    1. Starting Diagnostic Mode (All elements come on during the SW check mode).
      1. Turn off the audio system and turn the ignition switch to the ACC position. While pressing the preset switches "1" and "6" at the same time, press the "DISC" 3 times.
        Fig 1: Pressing Preset Switches "1" & "6" And Pressing "DISC" 3 Times
        G03049429Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Reference:
        • When the system enters the Diagnostic Mode, a beep sound is emitted 3 times and all the elements come on during the SW check mode.
        • It takes about 40 seconds to complete the check.
        • Turn all the elements in the LCD on.
        • When pressing the switch, confirm a beep sound is emitted.
    2. Service Check Screen.
      1. Press the "SEEK TRACK" switch to enter the "Service Check Screen".
      2. In the service check mode, the system check and the diagnostic memory check are performed, and the check results are displayed in ascending order of the component codes (physical address.)
      Fig 2: Service Check Screen Chart
      G03049430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Code No. (physical address) List 

      CODE NO. (PHYSICAL ADDRESS)

      Code No. (physical address) Equipment name
      190 Radio receiver assy (Audio head unit)
      440 Stereo component amplifier assy
    3. Finishing Diagnostic Mode.
      1. Press the "DISC" for 2 seconds or more, or turn the ignition switch off.
    4. Service Check Mode Result Display (for checking the current and the past system conditions).
      1. Press the "SEEK TRACK" switch to see the check result of each component.
        Fig 3: Diagnosis Mode - Result Display
        G03049431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Check Result Display.
        Fig 4: Check Result Display Specifications Table (1 Of 2)
        G03049432Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.