Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 684 (SEAT (SERVICE SPECIFICATIONS))TORQUE SPECIFICATION
2004 Toyota Matrix XR, FWD, Standard
Torque Specification
2004 Toyota Matrix XR, FWD, StandardSECTION Torque Specification
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Part Tightened | N.m | kgf-cm | ft.lbf |
|---|---|---|---|
| FRONT SEAT ASSY | |||
| Airbag sensor x Seat adjuster assembly | 8 | 82 | 71 in.lbf |
| Seat Inner belt assembly x Seat adjuster assy | 42 | 428 | 31 |
| Seatback cover bracket x Seat adjuster assy (w/ Side airbag) | 5.5 | 56 | 48 in.lbf |
| Seat assy x Body | 37 | 375 | 27 |
| REAR SEAT ASSY (COUPE) | |||
| Seatback hinge sub-assy x Seatback frame | 18 | 185 | 13 |
| Seatback hinge sub-assy center x Seatback frame | 13 | 135 | 10 |
| Seatback hinge sub-assy center x Body | 18 | 185 | 13 |
| Seatback lock assy x Seatback frame | 30 | 306 | 22 |
| REAR SEAT ASSY (CONVERTIBLE) | |||
| Seatback x Body | 18.1 | 185 | 13 |
| Seat belt assy outer (anchor plate) x Body | 42 | 428 | 31 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.