SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 670 (AUDIO & VISUAL SYSTEM)NAVIGATION ANTENNA ASSYREPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Navigation Antenna ASSY: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

COMPONENTS: See COMPONENTS 

  1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
  2. REMOVE SPARE WHEEL COVER ASSY 
  3. REMOVE LUGGAGE COMPARTMENT TRIM HOOK NO. 1 (See  REPLACEMENT  ) 
  4. REMOVE REAR FLOOR FINISH PLATE (See  REPLACEMENT  ) 
  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LH (See  REPLACEMENT  ) 
  6. REMOVE REAR SEAT CUSHION ASSY (See  REAR SEAT ASSEMBLY (FROM JULY, 2003)  ) 
  7. REMOVE REAR SEAT BACK ASSY RH (See  REAR SEAT ASSEMBLY (FROM JULY, 2003)  ) 
  8. REMOVE REAR SEAT BACK ASSY LH (See  REAR SEAT ASSEMBLY (FROM JULY, 2003)  ) 
  9. REMOVE REAR SIDE SEAT BACK ASSY RH (TMC MADE) (See  REAR SEAT ASSEMBLY (FROM JULY, 2003)  ) 
  10. REMOVE REAR SIDE SEAT BACK ASSY LH (TMC MADE) (See  REAR SEAT ASSEMBLY (FROM JULY, 2003)  ) 
  11. REMOVE ROOF SIDE GARNISH INNER RH (W/O CURTAIN SHIELD AIR BAG) (See  REPLACEMENT  ) 
  12. REMOVE ROOF SIDE GARNISH INNER LH (W/O CURTAIN SHIELD AIR BAG) (See  REPLACEMENT  ) 
  13. REMOVE ROOF SIDE GARNISH INNER RH (W/ CURTAIN SHIELD AIR BAG) (See  REPLACEMENT  ) 
  14. REMOVE ROOF SIDE GARNISH INNER LH (W/ CURTAIN SHIELD AIR BAG) (See  REPLACEMENT  ) 
  15. REMOVE REAR SEAT SHOULDER BELT COVER RH (See  REPLACEMENT (TMC MADE)  or  REPLACEMENT (TMMK MADE)  ) 
  16. REMOVE PACKAGE TRAY TRIM PANEL ASSY (TMC MADE) (See  REPLACEMENT  ) 
  17. REMOVE REAR SEAT 3 POINT TYPE BELT ASSY OUTER (TMC MADE) (See  REPLACEMENT (TMC MADE)  ) 
  18. REMOVE REAR SEAT INNER W/CENTER BELT ASSY RH (TMC MADE) (See  REPLACEMENT (TMC MADE)  ) 
  19. REMOVE REAR SEAT INNER W/CENTER BELT ASSY LH (TMC MADE) (See  REPLACEMENT (TMC MADE)  ) 
  20. REMOVE ROOM PARTITION BOARD LH (TMC MADE) (See  REPLACEMENT  ) 
  21. REMOVE ROOM PARTITION BOARD RH (TMC MADE) (See  REPLACEMENT  ) 
  22. REMOVE NAVIGATION ANTENNA ASSY 
    1. Disconnect the connector.
    2. Tie the string at the tip of the cable of the navigation antenna assy.
      Fig 1: Identifying Tie String At Tip Of Cable
      G02891027Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the screw.
    4. Remove the clamp and navigation antenna assy.
    NOTE: As the string is used at the time of installation, remain it putting through the luggage room and the room side.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.