SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 662 (MANUAL TRANS)FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECTREPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Floor Shift Cable Transmission Control Select: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSY (See  REPLACEMENT  ) 
  2. REMOVE AIR CONDITIONING RADIATOR ASSY (See  OVERHAUL  ) 
  3. REMOVE AIR BAG SENSOR ASSY CENTER (see  REMOVAL & INSTALLATION  ) 
  4. REMOVE FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT 
    1. Remove the clip and washer and separate the top of the select cable from the transaxle.
    2. Remove the clip and select cable from the control cable bracket.
    3. Turn the lock and separate the select cable from the shift lever retainer.
    4. Remove the clip and separate the top of the select cable from the shift lever assy.
    5. Remove the 2 retainer set bolts from the floor.
    6. Separate the retainer from the grommet.
    7. Remove the select cable from the grommet.
    8. Remove the select cable through the floor hole and retainer.
  5. INSTALL FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT 
    1. Put the select cable through the floor hole and retainer.
    2. Install the select cable to the grommet.
    3. Install the retainer to the grommet.
      Fig 1: Removing Retainer Set Bolts From Floor
      G02890178Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.