SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 638 (ENGINE CONTROL SYSTEM (SFI) (1MZ-FE/3MZ-FE))ACCELERATOR PEDAL ASSEMBLY (1MZ-FE/3MZ-FE)REPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Accelerator Pedal Assembly (1MZ-FE/3MZ-FE): Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE ACCELERATOR PEDAL ASSY 
    1. Disconnect the accelerator position sensor connector.
    2. Remove the 2 bolts and the accelerator pedal.
      Fig 1: Removing Accelerator Pedal Assembly
      G02892193Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ACCELERATOR PEDAL ASSY 
    1. Connect the accelerator position sensor connector.
    2. Install the accelerator pedal with the 2 bolts.

      Torque: 7.5 N.m (76 kgf.cm, 66 in.lbf) 

      Fig 2: Installing Accelerator Pedal Assembly
      G02892194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.