SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 626 (NAVIGATION SYSTEM - DIAGNOSTICS)POWER SOURCE CIRCUIT (RADIO AND NAVIGATION ASSY)INSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard

Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT RADIO AND NAVIGATION ASSY (+B, ACC, GND) 
    1. Disconnect the radio and navigation assy connector R4.
    2. Measure the resistance according to the value (s) in the table below.

      Standard: 

      TERMINALS RESISTANCE

      Tester connection Condition Specified condition
      GND - Body ground Always Below 1 Ω
      Fig 1: Disconnecting Radio And Navigation Assy Connector R4
      G02895063Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the voltage according to the value (s) in the table below.

      Standard: 

      TERMINALS VOLTAGE

      Tester connection Condition Specified condition
      +B - GND Always 10 to 14 V
      ACC - GND Ignition SW ACC 10 to 14 V
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE OR DIAGNOSTIC TROUBLE CODE CHART (see  PROBLEM SYMPTOMS TABLE   or  DIAGNOSTIC TROUBLE CODE CHART  ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.