Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISPLAY CHECK MODE (VEHICLE SIGNAL CHECK MODE) 
    1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (see DISPLAY CHECK MODE (VEHICLE SIGNAL CHECK) ).
    2. Turn the light control switch TAIL or ON and OFF.

      Standard: 

      LIGHT CONTROL SWITCH

      Light Control Switch Display
      TAIL or ON ON
      OFF OFF

      HINT:

      This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.

      Fig 1: Display Check Mode - Vehicle Signal Check Mode
      G02895019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK: REPLACE RADIO AND NAVIGATION ASSY (SEE  REPLACEMENT  ) 
    2. NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (see  PROBLEM SYMPTOMS TABLE  ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.