SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 624 (LIGHTING SYSTEM - DIAGNOSTICS)HEADLIGHT DOES NOT LIGHT UPINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard

Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT HEADLAMP RELAY 
    1. Inspect relay continuity.

      Standard: 

      SPECIFIED CONDITION

      Condition Tester connection Specified condition
      Constant 1 - 2 Continuity
      Apply B+ between terminal 1 and 2. 3 - 5 Continuity
      Fig 1: Inspecting Headlamp Relay
      G02894852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPLACE HEADLAMP RELAY 
    2. OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (BETWEEN INSTRUMENT PANEL J/B ASSY AND HEADLAMP RELAY) 
  2. INSPECT HEADLAMP DIMMER SWITCH ASSY (HEAD) 
    1. Inspect light control switch continuity.
      1. Check that there is continuity between terminals at each switch position as shown in the chart.
      SPECIFIED CONDITION

      Switch operation Tester connection Specified condition
      OFF - No continuity
      HEAD 13 - 16 - 14 Continuity
      Fig 2: Inspecting Headlamp Dimmer Switch Assembly
      G02894853Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPLACE HEADLAMP DIMMER SWITCH ASSY 
    2. OK: CHECK AND REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSY 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.