Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 612 (INTAKE - SERVICE SPECIFICATIONS)TORQUE SPECIFICATION2AZ-FE

2004 Toyota Matrix XR, FWD, Standard

Torque Specification: 2AZ-FE

2004 Toyota Matrix XR, FWD, StandardSECTION 2AZ-FE

WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

2AZ-FE TORQUE SPECIFICATION

Part Tightened	N.m	kgf.cm	ft.lbf
Intake manifold x Cylinder head	30	306	22
Air cleaner cap sub-assy x Air cleaner case sub-assy	5.0	51	44 in.lbf
Engine cover sub-assy No. 1 x Cylinder head cover sub-assy	7.0	71	62 in.lbf

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.