Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 559 (PROPELLER SHAFT)INSTALLATIONINSTALL PROPELLER SHAFT
2004 Toyota Matrix XR, FWD, Standard
Install Propeller Shaft
2004 Toyota Matrix XR, FWD, StandardSECTION Install Propeller Shaft
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Remove SST from the transmission.
SST 09325-40010
- Insert the yoke into the transmission.
- Align the matchmarks on the flanges and connect the flanges with the 4 stud bolts, washers and nuts.
- Torque the 4 nuts.
Torque: 74 N.m (750 kgf.cm, 54 ft.lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.