Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 558 (TRANSFER CASE)TRANSFER ASSEMBLYDISASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
Transfer Assembly: Disassembly
2004 Toyota Matrix XR, FWD, StandardSECTION Disassembly
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE VEHICLE SPEED SENSOR ASSEMBLY
- Remove the bolt and vehicle speed sensor assembly.
- Using a small screwdriver, remove the clip and vehicle speed sensor driven gear.
- Using a small screwdriver, remove the O-ring.
Tape the small screwdriver tip before use.
- REMOVE L4 POSITION SWITCH, NEUTRAL POSITION SWITCH AND STRAIGHT SCREW PLUG WITH 3 GASKETS
- REMOVE FRONT BEARING RETAINER
Remove the 5 bolts and front bearing retainer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.