Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 544 (AUTOMATIC TRANSMISSION - DIAGNOSTICS)
2004 Toyota Matrix XR, FWD, Standard
Section 544 (Automatic Transmission - Diagnostics)
2004 Toyota Matrix XR, FWD, StandardSECTION Section 544 (Automatic Transmission - Diagnostics)
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- How To Proceed With Troubleshooting
- Customer Problem Analysis Check
- Pre-Check
- Diagnostic Trouble Code Chart
- Parts Location
- Terminals Of ECM
- Problem Symptoms Table
- Circuit Inspection
- Diagnostic Trouble Code Definitions
- DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input)
- DTC P0710: Transmission Fluid Temperature Sensor "A" Circuit, DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low Input, DTC P0713: Transmission Fluid Temperature Sensor "A" Circuit High Input
- DTC P0717: Input Speed Sensor Circuit No Signal
- DTC P0722: Output Speed Sensor Circuit No Signal
- DTC P0724: Brake Switch "B" Circuit High
- DTC P0741: Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL)
- DTC P0743: Torque Converter Clutch Circuit Electrical
- DTC P0751: Shift Solenoid "A" Performance (Shift Solenoid Valve S1), DTC P0756: Shift Solenoid "B" Performance (Shift Solenoid Valve S2)
- DTC P0818: Driveline Disconnect Switch Input Circuit
- DTC P0973: Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1), DTC P0974: Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1), DTC P0976: Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2), DTC P0977: Shift Solenoid "B" Control Circuit High (Shift Solenoid Valve S2)
- DTC P1782: T/F L4 Range Position Switch Performance
- DTC P2716: Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT)
- O/D Main Switch &O/D OFF Indicator Light Circuit
- A/T. P. (Automatic Transmission Parking) Indicator Light Circuit
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.