Compressor And Magnetic Clutch: Removal

2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2003 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES 
  2. STOP ENGINE 
  3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY 
  4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM 
  5. REMOVE DRIVE BELT (See  REMOVAL   ) 
  6. DISCONNECT DISCHARGE AND SUCTION HOSES 

    Remove the 2 nuts and disconnect the both hoses.

    NOTE: Cap the open fitting immediately to keep moisture or dirt out of the system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.