Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 53 (ELECTRICAL COMPONENT LOCATOR)GROUNDS
2004 Toyota Matrix XR, FWD, Standard
Section 53 (Electrical Component Locator): Grounds
2004 Toyota Matrix XR, FWD, StandardSECTION Grounds
WARNING: This page is about a different car, the 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS LOCATION
| Component | Component Location |
|---|---|
| BA | At left center pillar. |
| BB | At right center pillar. |
| BC | At left side of rear crossmember. |
| BD | At right side of rear crossmember. |
| BE | At left side of back door. |
| EA (2.4L) | At right front fender apron. See Figure. |
| EA (3.0L) | At right front fender apron. See Figure. |
| EB (2.4L) | At right front fender apron. See Figure. |
| EB (3.0L) | At right front fender apron. See Figure. |
| EC (3.0L) | At right side of surge tank. See Figure. |
| ED (3.0L) | At rear side of surge tank. See Figure. |
| EE (2.4L) | At intake side of cylinder block. See Figure. |
| EF (2.4L) | At left side of cylinder block. See Figure. |
| EG (2.4L) | Under left headlight. See Figure. |
| EG (3.0L) | Under left headlight. See Figure. |
| EH (2.4L) | Under left headlight. See Figure. |
| EH (3.0L) | Under left headlight. See Figure. |
| IA | At left kick panel. See Figure. |
| IB | At right dash brace. See Figure. |
| IC | At right kick panel. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.