Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 507 (INTRODUCTION)IDENTIFICATION INFORMATIONVEHICLE IDENTIFICATION AND SERIAL NUMBERS
2004 Toyota Matrix XR, FWD, Standard
Vehicle Identification And Serial Numbers
2004 Toyota Matrix XR, FWD, StandardSECTION Vehicle Identification And Serial Numbers
WARNING: This page is about a different car, the 2004 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- VEHICLE IDENTIFICATION NUMBER
- The vehicle identification number is stamped on the vehicle identification number plate and certification label, as shown in the illustration.
A: Vehicle Identification Number Plate
B: Certification Label
- The vehicle identification number is stamped on the vehicle identification number plate and certification label, as shown in the illustration.
- ENGINE SERIAL NUMBER AND MOTOR SERIAL NUMBER
- The engine serial number is stamped on the engine block, as shown in the illustration.
A: Engine Serial Number
- The motor serial number is stamped on the motor as shown in the illustration.
B: Motor Serial Number
- The engine serial number is stamped on the engine block, as shown in the illustration.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.