Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 493 (REAR BRAKE SPEED SENSOR)REASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
Section 493 (Rear Brake Speed Sensor): Reassembly
2004 Toyota Matrix XR, FWD, StandardSECTION Reassembly
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
2WD:
INSTALL NEW SPEED SENSOR
- Clean the contacting surface of the axle hub and a new speed sensor.NOTE: Do not allow any foreign matter to stick to the sensor rotor.
- Place the speed sensor on the axle hub so that the connector is set at the bottom under the on-vehicle condition.
- Using SST and a press, install a new ABS speed sensor to the axle hub.
SST 09527-10011, 09710-04101, 09950-60020 (09951-00680)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.