Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 493 (REAR BRAKE SPEED SENSOR)DISASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
Section 493 (Rear Brake Speed Sensor): Disassembly
2004 Toyota Matrix XR, FWD, StandardSECTION Disassembly
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
2WD:
REMOVE ABS SPEED SENSOR
- Using a pin punch and hammer, drive out the 2 pins, and remove the 2 attachments from SST.
SST 09520-00031 (09520-00040, 09521-00020)
- Mount the axle hub assembly in a soft jaw vise.NOTE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.
- Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the ABS speed sensor.
SST 09520-00031 (09520-00040, 09521-00020), 09950-00020
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.