Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (MANUAL A/C-HEATER SYSTEMS)DRIVE BELTINSTALLATION

2004 Toyota Matrix XR, FWD, Standard

Drive Belt: Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Installation

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

5VZ-FE engine: Install drive belt.
1. Tighten the idle pulley lock nut temporally.
  Torque: 2.5 N.m (25 kgf.Cm, 22 in.lbf)
2. Install the drive belt.
3. Apply drive belt tension by adjusting bolt.
  1. Drive belt tension:
  2. New belt: 160 +/- 25 lbf
  3. Used belt: 100 +/- 25 lbf
4. Tighten the idle pulley lock nut.
  1. Torque: 39 N.m (400 kgf.Cm, 29 ft.lbf)
5. Install the engine under cover.
2UZ-FE engine: Install drive belt.
1. Turn the drive belt tensioner counterclockwise then install the drive belt.
  
  Fig 2: Tightening Drive Belt Tensioner For Removal Of Drive Belt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.