Torque Specification

2004 Toyota Matrix XR, FWD, StandardSECTION Torque Specification
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE (U140F) SPECIFICATIONS

Part tightened N.m kgf.cm ft.lbf
Vehicle speed sensor x Transaxle case 5.5 56 49 in..lbf
Input turbine speed sensor x Transaxle case 11.3 115 8
Counter gear speed sensor x Transaxle case 11.3 115 8
ATF Temperature sensor x Valve body 6.6 67 58 in..lbf
Oil pan x Transaxle case 7.6 80 67 in..lbf
Drain plug 47 480 35
Solenoid wire x Transaxle 5.4 55 48 in..lbf
Park/neutral position switch x Transaxle Bolt 5.4 55 48 in..lbf
Nut 6.9 70 61 in..lbf
Control shaft lever x Shift control shaft 12.7 130 9
Shift control cable x Control shaft lever 15 150 11
Solenoid valve x Valve body Bolt A 6.6 67 58 in..lbf
(See Valve Body Assembly in Automatic Transaxle (U140F) Bolt B 10.8 110 8
Valve body x Transaxle case 10.8 110 8
Oil strainer x Valve body 11 110 8
Transmission oil cooler x Bracket 18 184 13
Floor shift assembly x Floor 12 122 9
Starter x Torque converter housing 37 380 27
Starter wire x Starter 13 130 10
Stiffener plate x Engine, Transaxle 34 347 25
Torque converter x Drive plate 41 420 30
Transaxle x Engine Upper side Β  Β  Β 
(See Removal in Automatic Transaxle Unit in Automatic Transaxle (U140F) Bolt A 64 653 47
Bolt B 46 469 34
Lower side 44 449 32
Drive plate x Engine 98 1,000 72
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.