Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 452 (AIR CONDITIONING SYSTEM - DIAGNOSTICS)CIRCUIT INSPECTIONDTC 11: ROOM TEMPERATURE SENSOR CIRCUITINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard
Inspection Procedure
2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- Check voltage between terminals TR and SGTR of A/C amplifier connector.
Preparation:
- Remove center cluster module control with connectors still connected.
- Turn the ignition switch ON.
Check: voltage between terminals TR and SGTR of A/C amplifier connector at each temperature. If OK , voltage at 25 °C (77 °F) : 1.8 - 2.2 V, at 40 °C (104 °F) : 1.2 - 1.6 V.
NOTE: As the temperature increases, the voltage decreases.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.