Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 451 (HYBRID VEHICLE CONTROL)CONVERTER AND INVERTER ASSEMBLYON-VEHICLE INSPECTION OF CONVERTER & INVERTER ASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
On-Vehicle Inspection Of Converter & Inverter Assembly
2004 Toyota Matrix XR, FWD, StandardSECTION On-Vehicle Inspection Of Converter & Inverter Assembly
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect inverter
:
- Turn the IG switch OFF and disconnect the 4 connectors.
- Apply battery positive voltage to connector B terminal 5 (IGCT) on the inverter side through a fuse, and battery negative voltage to connector B terminal 6 (GND).
- Measure the voltage and resistance between each terminal shown in Fig 1 and Fig 2 and ground.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.