SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 438 (INTERIOR LIGHT SYSTEM)INTERIOR LIGHT SYSTEMINSPECTIONSTEP 2 - INSPECT INTERIOR LIGHT CONTINUITY
2004 Toyota Matrix XR, FWD, Standard

Step 2 - Inspect Interior Light Continuity

2004 Toyota Matrix XR, FWD, StandardSECTION Step 2 - Inspect Interior Light Continuity
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the room light.
  2. Turn the room light switch ON, check that continuity exists between terminal 1 and body ground.
    Fig 1: Testing Interior Light
    G01895452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If continuity is not as specified, replace the light assembly or bulb.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.