Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 435 (COMBINATION METER)TROUBLESHOOTINGPROBLEM SYMPTOMS TABLEMETER GAUGES AND ILLUMINATION: COMBINATION METER
2004 Toyota Matrix XR, FWD, Standard
Meter Gauges And Illumination: Combination Meter
2004 Toyota Matrix XR, FWD, StandardSECTION Meter Gauges And Illumination: Combination Meter
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
COMBINATION METER (METER, GAUGES AND ILLUMINATION)
| Symptom/Suspect Area | See | |
|---|---|---|
| Fuel Gauge & Water Temperature Gauge Does Not Operate | ||
| Gauge Fuse | Replace Fuse | |
| Meter Circuit Plate | COMBINATION METER CIRCUIT | |
| Wire Harness | Repair Or Replace | |
| Speedometer Does Not Operate | ||
| Vehicle Speed Sensor | STEP 3 - INSPECT INPUT SPEED SIGNAL | |
| Meter Circuit Plate | COMBINATION METER CIRCUIT | |
| Wire Harness | Repair Or Replace | |
| Tachometer Does Not Operate | ||
| Igniter | Repair Or Replace | |
| Engine And ECT ECU | Repair Or Replace | |
| Meter Circuit Plate | COMBINATION METER CIRCUIT | |
| Wire Harness | Repair Or Replace | |
| Fuel Gauge Does Not Operate Or Abnormal Operation | ||
| Fuel Tank Assembly | Repair Or Replace | |
| Wire Harness | Repair Or Replace | |
| All Illumination Lights Do Not Light Up | ||
| Tail Fuse | Replace Fuse | |
| Meter Circuit Plate | COMBINATION METER CIRCUIT | |
| Wire Harness | Repair Or Replace | |
| Only One Illumination Light Does Not Light Up | ||
| Bulb | Replace Bulb | |
| Wire Harness | Repair Or Replace | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.