Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 429 (STEERING SYSTEM)TILT STEERING COLUMNINSTALLATIONSTEP 7 - CONNECT INTERMEDIATE SHAFT SUB-ASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
Step 7 - Connect Intermediate Shaft Sub-Assembly
2004 Toyota Matrix XR, FWD, StandardSECTION Step 7 - Connect Intermediate Shaft Sub-Assembly
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
For Bolt locations, see Figure.
- Align the matchmarks on the intermediate shaft sub-assembly and control valve shaft.
- Install the bolt B.
Torque: 35 N.m (360 kgf.cm,26 ft.lbf) .
- Torque the bolt A.
Torque: 35 N.m (360 kgf.cm, 26 ft.lbf) .
- Connect the No. 2 column hole cover sub-assembly and tighten the clamp.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.