Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 425 (POWER SEAT CONTROL SYSTEM)
2004 Toyota Matrix XR, FWD, Standard
Section 425 (Power Seat Control System)
2004 Toyota Matrix XR, FWD, StandardSECTION Section 425 (Power Seat Control System)
WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
- Power Seat Control System
- Notes
- Location
- Inspection
- Step 1 - Inspect Power Seat Switch Continuity (Slide Switch)
- Step 2 - Inspect Power Seat Switch Circuit
- Step 3 - Inspect Lumbar Support Switch Continuity
- Step 4 - Inspect Lumbar Support Switch Circuit
- Step 5 - Inspect Slide Motor Operation
- Step 6 - Inspect Slide Motor PTC Thermistor Operation
- Step 7 - Inspect Front Tilt Motor Operation
- Step 8 - Inspect Front Tilt Motor PTC Thermistor Operation
- Step 9 - Inspect Rear Lifter Motor Operation
- Step 10 - Inspect Rear Lifter Motor PTC Thermistor Operation
- Step 11 - Inspect Reclining Motor Operation
- Step 12 - Inspect Reclining Motor PTC Thermistor Operation
- Step 13 - Inspect Lumbar Support Motor Operation
- Step 14 - Inspect Lumbar Support Motor Circuit Breaker Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.