SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 400 (2002 AIR CONDITIONING)BLOWER UNITREMOVAL
2004 Toyota Matrix XR, FWD, Standard

Blower Unit: Removal

2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove Instrument Panel (See  REMOVAL & INSTALLATION  ) 
  2. Remove Air Duct (Duct Side) 
    1. Disconnect the connector and connector clamp.
      Fig 1: Removing Air Duct From A/C System
      G01178960Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the screw.
    3. Release the 2 claws and pull out the air duct.
  3. Disconnect Wire Harness 
    1. Disconnect the connector and connector clamp.
      Fig 2: Locating Air Duct Connector Harness
      G01178961Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the wire harness clamp and disconnect the connector.
      3. Fig 3: Removing Wire Harness Clamp & Disconnecting Connector
      G01178962Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. Remove Blower Unit 
    1. Remove the 2 bolts and bracket.
    2. Remove the bolt, screw and nut.
    3. Release the claw and remove the blower unit.
    Fig 4: Removing Blower Unit From A/C System
    G01178963Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.