Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 40 (ENGINE CONTROLS - TROUBLE SHOOTING - NO CODES)SYMPTOMSPOOR DRIVEABILITY
2004 Toyota Matrix XR, FWD, Standard
Poor DRIVEABILITY
2004 Toyota Matrix XR, FWD, StandardSECTION Poor DRIVEABILITY
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
Hesitation/Poor Acceleration
- Check fuel pump control circuit. On all models except LX470, see FUEL PUMP CONTROL CIRCUIT under FUEL SYSTEM in appropriate SYSTEM & COMPONENT TESTING article. On LX470, perform DTC P1200: FUEL PUMP RELAY/ECU CIRCUIT test in SELF-DIAGNOSTICS - LX470 article.
- Check for faulty automatic transmission (electronics). See appropriate ELECTRONIC CONTROLS article in AUTOMATIC TRANSMISSIONS.
Surging
- Check fuel pump control circuit. On all models except LX470, see FUEL PUMP CONTROL CIRCUIT under FUEL SYSTEM in appropriate SYSTEM & COMPONENT TESTING article. On LX470, perform DTC P1200: FUEL PUMP RELAY/ECU CIRCUIT test in SELF-DIAGNOSTICS - LX470 article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.