Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
CMP sensor consists of a 3-tooth signal plate and a pick-up coil. Signal plate is mounted on camshaft. DTC is set when no camshaft position signal is received by ECM from CMP sensor during cranking. DTC is also set when no camshaft position signal is received by ECM from CMP sensor with engine speed of 600 RPM or more. Possible causes are:
- CMP sensor open or short circuit.
- Faulty CMP sensor.
- Faulty ECM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.