SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 371 (BACK DOOR CONTROL SYSTEMS)SYSTEM TESTSBACK DOOR LOCK MOTOR CIRCUITINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard

Inspection Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In case of using the TOYOTA hand-held tester, start the inspection from step 1 and in case of not using the TOYOTA hand-held tester, start from step  2.
  1. Check The Back Door Lock Motor Using TOYOTA Hand-Held Tester. 

    PREPARATION:  Connect the TOYOTA hand-held tester to the DLC3.

    CHECK:  that the back door lock motor can operate in an ACTIVE TEST.

    1. OK:  Proceed to next circuit inspection shown on problem symptom table. See PROBLEM SYMPTOMS TABLE .
    2. NG  : Go to step  2.
  2. Check  Back Door Lock Motor  . 
    1. NG:  Replace the back door lock motor.
    2. OK:  Go to step  3.
  3. Check Wiring Harness And Connector Between Back Door Lock Motor And Back Door ECU. 
    1. NG:  Repair or replace wiring harness or connector.
    2. OK:  Proceed to next circuit inspection shown on problem symptoms table . SeePROBLEM SYMPTOMS TABLE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.