Deployment Tool Test

2004 Toyota Matrix XR, FWD, StandardSECTION Deployment Tool Test
WARNING: This page is about a different car, the 2004 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using Deployment Tool (SMD 4082/1), connect Blue and Yellow connectors of tool lead into corresponding sockets on face of deployment tool.
  2. Connect alligator clips of tool lead to 12-volt battery (Red clip to positive terminal and Black clip to negative terminal). Red "READY" light on face of deployment tool should illuminate. Depress and hold both buttons on face of deployment tool. Green "DEFECTIVE" light should illuminate. Release both buttons. Red "READY" light will illuminate again. Disconnect tool from battery and disconnect Blue and Yellow connectors from face of tool. Tool is ready for use.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.