Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 367 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESON-VEHICLE DEPLOYMENT (SCRAPPED VEHICLES ONLY)DRIVER- & PASSENGER-SIDE AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Driver- & Passenger-side AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Driver- & Passenger-side AIR Bag Module
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disconnect negative battery cable. Wait at least 90 seconds. Ensure steering wheel, driver-side air bag and passenger-side air bag modules are not loose. If components are loose, remove and deploy air bag(s) using OFF-VEHICLE DEPLOYMENT procedure. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL .
- If deploying driver-side air bag module, remove lower steering column cover and disconnect air bag electrical connector at spiral cable. If deploying passenger-side air bag, remove instrument panel under cover subassembly No. 1 and right instrument panel finish lower panel. Disconnect passenger-side air bag connector.
- For driver-side air bag, connect deployment tool and Deployment Tool Subharness Adapter (09082-00802) to air bag module connector at spiral cable. For passenger-side air bag, connect deployment tool and deployment tool subharness adapter to air bag module connectors. Position deployment tool and 12 volt service battery at least 33 feet (10 m) from front of vehicle. Close all doors and windows of vehicle.
- Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Ensure no one is inside vehicle or within 33 feet (10 m) of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.