Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 367 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTCURTAIN AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Curtain AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Curtain AIR Bag Module
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL . Remove curtain air bag module. See CURTAIN AIR BAG MODULE under REMOVAL & INSTALLATION.
- Remove tape from air bag module. Cut deployment section (bag material) of air bag module from inflator. Pass strong wire through air bag module mounting holes. Position curtain air bag module inside a scrap tire with air bag deployment direction facing inside. See Fig 1. Connect Deployment Tool Subharness Adapter (09082-00760) to curtain air bag module connector. Secure curtain air bag module to tire with wire. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire.
- Connect deployment tool to deployment tool subharness adapter. Position deployment tool and 12 volt service battery at least 33 feet (10 m) away from curtain air bag. Press activation switch to deploy curtain air bag. Because of heat, wait 30 minutes before handling curtain air bag. Seal deployed air bag module in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.