Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 357 (HVAC - GENERAL SERVICING)TORQUE SPECIFICATIONS
2004 Toyota Matrix XR, FWD, Standard
Torque Specifications
2004 Toyota Matrix XR, FWD, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Clutch Pressure Plate-To-Compressor Shaft Bolt | 13 (18) | |
| Compressor Mounting Bolt/Nut | ||
| Bolt | 35 (47) | |
| Nut | 18 (24) | |
| Passenger's Side Air Bag-To-Instrument Panel Reinforcement Bolt | 15 (20) | |
| Steering Wheel Nut | 37 (51) | |
| Tube & Accessory-To-Expansion Valve Nut For Rear A/C Cooling Unit | 16 (22) | |
| INCH Lbs. (N.m) | ||
| Driver's Side Air Bag Torx Screw | 78 (8.8) | |
| Expansion Valve Bolt For Front A/C Cooling Unit | 31 (3.5) | |
| Liquid Tube-To-Expansion Valve Nut For Rear A/C Cooling Unit | 89 (10.1) | |
| Passenger's Side Air Bag-To-Instrument Panel Bolt | 44 (5.0) | |
| Pressure Switch | 89 (10.1) | |
| Refrigerant Line-To-Compressor Bolt | 89 (10.1) | |
| Refrigerant Line-To-Condenser Bolt | 48 (5.4) | |
| Refrigerant Line-To-Rear A/C Cooling Unit Nut | 48 (5.4) | |
| Refrigerant Line-To-Receiver Bolt | 48 (5.4) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.