Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 357 (HVAC - GENERAL SERVICING)COMPRESSOR AND MAGNETIC CLUTCHDISASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
Compressor And Magnetic Clutch: Disassembly
2004 Toyota Matrix XR, FWD, StandardSECTION Disassembly
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Remove pressure plate
- Using SST and a socket wrench, remove the shaft bolt. See Fig 1.
SST 07112-76060
Torque: 18 N.m (184 kgf.cm, 12.3 ft.lbf)
- Install SST on the pressure plate. See Fig 2.
SST 07112-66040
- Using SST and socket wrench, remove the pressure plate. See Fig 3.
SST 07112-66040, 07112-76060,
- Remove the shims from the pressure plate. See Fig 4.
- Using SST and a socket wrench, remove the shaft bolt. See Fig 1.
- Remove rotor
: NOTE: The snap ring should be installed so that beveled side faces up. See Fig 6.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.