Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 356 (AUTOMATIC TRANSMISSION SERVICING)REMOVAL & INSTALLATIONOUTPUT SPEED SENSORREMOVAL

2004 Toyota Matrix XR, FWD, Standard

Output Speed Sensor: Removal

2004 Toyota Matrix XR, FWD, StandardSECTION Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect battery negative cable.
Raise vehicle on hoist.
Disconnect output speed sensor connector. See Figure .
Unscrew and remove output speed sensor. See Fig 1 .
Inspect speed sensor O-ring and replace if necessary. See Fig 2 .

Fig 1: Removing Output Speed Sensor

Courtesy of CHRYSLER CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.