Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 356 (AUTOMATIC TRANSMISSION SERVICING)ADJUSTMENTSGEARSHIFT CABLE
2004 Toyota Matrix XR, FWD, Standard
Gearshift Cable
2004 Toyota Matrix XR, FWD, StandardSECTION Gearshift Cable
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Park vehicle on level surface. Apply parking brake. Place gearshift lever in Park and remove ignition key. Loosen gearshift cable adjustment screw at the transaxle manual valve lever. See Fig 1 .
- Pull the gearshift operating lever fully forward to Park detent position. Release parking brake and move vehicle backward and forward to ensure transaxle is in Park.
- Tighten the cable adjustment screw to 70 INCH Lbs. (8 N.m.). Gearshift cable should now be properly adjusted.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.