Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
RES/ACC Switch
Resetting To A Faster Speed
Push the lever up in the "RES/ACC" direction and hold it. See Figure. Release the lever when the desired speed is attained. While the lever is held up, the vehicle will gradually gain speed.
However, a faster way to reset is to accelerate the vehicle then push the lever down in the "SET/COAST" direction.
Resuming The Preset Speed
If the preset speed is cancelled by pulling the control lever or by depressing the brake pedal, pushing the lever up in the "RES/ACC," see Figure, direction will restore the speed set prior to cancellation.
However, once the vehicle speed falls below about 25 mph (40 km/h), the preset speed will not be resumed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.