Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 345 (GENERATORS & REGULATORS)GENERATOR SPECIFICATIONS
2004 Toyota Matrix XR, FWD, Standard
Generator Specifications
2004 Toyota Matrix XR, FWD, StandardSECTION Generator Specifications
WARNING: This page is about a different car, the 2004 Lexus LS 430 and 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
GENERATOR SPECIFICATIONS
| Application | Specification | ||||
|---|---|---|---|---|---|
| Brush Length | |||||
| 2003 | |||||
| Standard | 0.413 in. (10.5 mm) | ||||
| Limit (Minimum) | More Than .177 in. (4.5 mm) | ||||
| 2004 | |||||
| Standard | 0.504-0.567 in. (12.8-14.4 mm) | ||||
| Limit (Minimum) | 0.059-0.453 in. (1.5-11.5 mm) | ||||
| Rotor | |||||
| Resistance (1) | |||||
| 2003 Models | 2.3-2.7 Ohms | ||||
| 2004 Models | 2.1-2.5 Ohms | ||||
| Slip Ring Diameter | |||||
| Standard | 0.559-0.567 in. (14.2-14.4 mm) | ||||
| Minimum | 0.504 in. (12.8 mm) | ||||
| Generator Regulated Output | |||||
| Amperage | |||||
| Without Load | 10 Or Less Amps | ||||
| With Load | 30 Or More Amps | ||||
| Voltage (1) | 13.2-14.8 Volts | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.