Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 340 (Generators & Regulators): Overhaul: Generator: Assembly
To assemble, reverse disassembly procedure. Use generator Pulley Set Nut Wrench Set (SST 09820-63011) to install generator pulley. Place SST "C" securely into a vise. Install SST "A" and "B" and generator into SST "C". See Fig 1. Before installing brush holder, push brushes back into holder and install .039" (1 mm) pin into brush holder hole. See Fig 2. Tighten pulley nut in the opposite direction of disassembly. See TORQUE SPECIFICATIONS . Using 21 mm socket, carefully press in generator coil. To complete assembly, reverse disassembly procedure. After completing assembly, verify rotor turns smoothly. After completing assembly, verify rotor turns smoothly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.