Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 324 (SUSPENSION SYSTEM - FRONT)TORQUE SPECIFICATIONS
2004 Toyota Matrix XR, FWD, Standard
Torque Specifications
2004 Toyota Matrix XR, FWD, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2004 Toyota Sequoia, 2003 Toyota Sequoia, and 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Adjusting Cam Bolts | 96 (130) | |
| Axle Hub Lock Nut | 203 (274) | |
| Brake Line Clamp-To-Knuckle Arm Bolt | 21 (28) | |
| Disc Brake Caliper | 90 (123) | |
| Drive Shaft Lock Nut | 173 (235) | |
| Lower Ball Joint-To-Lower Control Arm Nut | 103 (140) | |
| Lower Ball Joint-To-Steering Knuckle Bolts | 59 (80) | |
| Lower Control Arm-To-Frame Bolts | 96 (130) | |
| Power Steering Gear Bolts/Nuts | ||
| "A" Bolt | 122 (165) | |
| "B" Nut | 96 (130) | |
| "C" Bolt & Nut | 122 (165) | |
| Shock Absorber-To-Frame Nuts | 47 (64) | |
| Shock Absorber-To-Lower Control Arm Bolt/Nut | 100 (135) | |
| Stabilizer Bar Link Nuts | 14 (19) | |
| Stabilizer Bar-To-Lower Control Arm Nuts | 51 (69) | |
| Steering Knuckle Dust Cover | 13 (18) | |
| Steering Knuckle-To-Upper Control Arm Bolt | 77 (105) | |
| Tie Rod End Lock Nuts | 41 (55) | |
| Tie Rod Ends-To-Lower Ball Joint Nuts | 67 (91) | |
| Upper Ball Joint-To-Upper Control Arm Nut | 77 (105) | |
| Upper Control Arm-To-Frame Nut | 72 (98) | |
| Wheel Lug Nut | 81 (110) | |
| INCH Lbs. (N.m) | ||
| ABS Speed Sensor Wire Harness | 71 (8) | |
| Brake & Fuel Line Clamp | 49 (5.5) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.